All rights reserved worldwide.Īll other brand names, product names, or trademarks belong to their respective holders.
ZEBRA Z4M PLUS MANUAL MANUAL
Proprietary Statement This manual contains proprietary information of Brady Corporation and its subsidiaries (“Zebra Technologies”). It is intended solely for the information and use of parties operating and maintaining the equipment described herein. Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without the express, written permission of Zebra Technologies. Product Improvements Continuous improvement of products is a policy of Zebra Technologies. All specifications and designs are subject to change without notice.
ZEBRA Z4M PLUS MANUAL MANUALS
Liability Disclaimer Zebra Technologies takes steps to ensure that its published Engineering specifications and manuals are correct however, errors do occur. Zebra Technologies reserves the right to correct any such errors and disclaims liability resulting therefrom. Limitation of Liability In no event shall Zebra Technologies or anyone else involved in the creation, production, or delivery of the accompanying product (including hardware and software) be liable for any damages whatsoever (including, without limitation, consequential damages including loss of business profits, business interruption, or loss of business information) arising out of the use of, the results of use of, or inability to use such product, even if Zebra Technologies has been advised of the possibility of such damages. Iv Compliance Information Compliance Information Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Operation is subject to the following two conditions:ġ. This device may not cause harmful interference, andĢ. This device must accept any interference received, including interference that may cause undesired operation.
The user is cautioned that any changes or modifications not expressly approved by Zebra Technologies could void the user’s authority to operate the equipment.
To ensure compliance, this printer must be used with Shielded Communication Cables.įCC Radiation Exposure Statement (for printers with RFID encoders) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
0 kommentar(er)
